Lockable Stainless Steel Ball Stretcher 14 mm, Ø 35 mm

Your introduction to ball stretching, in solid steel

The ball stretcher is a classic of cock and ball torture: a thick ring that sits around the top of the sack, between the testicles and the shaft, and pushes them down. Its height stretches the skin, its weight pulls permanently. The taller and heavier it is, the stronger the constraint.

This Triune model is 14 mm high: the lowest in the range, which goes up to 56 mm. In polished stainless steel, with a wall 10 mm thick and a 35 mm inner diameter, it weighs 190 g. Enough to clearly feel the effect, without rushing the steps.

Its strong points

The right size to start with. 14 mm is enough to feel the stretch and the weight from the moment you put it on, and low enough to wear comfortably through a session. Once you're used to it, you can move up to a taller height.

A real weight working for you. 190 g of steel hanging from your sack: with every step, every movement of your hips, you feel it pulling. The tension is constant, discreet and terribly present.

A locked closure. The stretcher is made of two half-rings joined by two screws. It only opens with the Allen key supplied: once screwed shut, it stays in place, and whoever holds the key decides when it comes off.

Polished steel, smooth and durable. No rough edges against the skin, no risk of warping, one-step cleaning and compatibility with all lubes.

What it makes you feel

Once on, the testicles are held low, the skin of the sack is taut and much more sensitive: a caress, a squeeze, a little slap become intense. The weight amplifies the sensation with every movement. Many fans also notice that orgasm comes less quickly, since the testicles can no longer rise. As for the look, the package is put on display, the balls hang lower, and the effect under a jock is immediate.

Solo, wear it while you jerk off or play with a plug. As a couple, your dom keeps the key, plays with the weight, pulls gently, flatters or roughs up your stretched balls. It's a submission accessory as much as a sensation toy.

How to put it on

• When soft, fully unscrew the two screws with the Allen key and separate the two halves.
• Gently pull the testicles down and place the two half-rings around the top of the sack, above the testicles.
• Check that no fold of skin is caught between the two halves.
• Screw the two screws back in gradually, one after the other, without forcing.
• Tip: run the steel under lukewarm water before putting it on to avoid the shock of cold metal.

Safety: listen to your body

Start with sessions of 15 to 20 minutes and lengthen them gradually. Always keep the Allen key within reach: without it, it's impossible to take off. Remove it immediately if you feel sharp pain, numbness, cold or if the sack turns bluish. Never sleep with it on, and skip it if you have circulation problems or take blood thinners. The ring must hold the testicles without compressing them: if it's too tight, don't push it.

Care

Wash it in hot water with mild soap after every use, dry the screw threads carefully and store it with its key. Stainless steel works with all lubes and is easy to disinfect.

Technical specifications

FAQ — Your questions, our answers

Q: I've never worn a ball stretcher, is this the right model?

A: Yes: at 14 mm high, it's the smallest in its range, designed to discover the stretch and the weight before moving on to taller models.

Q: How do I know if the 35 mm diameter suits me?

A: With your testicles pulled down, measure around the top of your sack with a flexible tape measure. The ring offers an inner circumference of about 11 cm: it must hold the testicles below without compressing the skin.

Q: How long can you keep it on?

A: Start with 15 to 20 minutes, then lengthen gradually if all goes well. Take it off at the slightest numbness or change of colour.

Q: What if I lose the key?

A: It's a standard Allen key: a key of the same size will also open the screws. Still, always keep it close while you wear it.