Stainless Steel Glans Ring with Ball Ø 30 mm - Acorn Ring

The little ring that puts your head under tension

The cock ring works at the base of the cock. The glans ring goes straight to the most sensitive spot. The Acorn Ring from Steel Power Tools is a ring in polished stainless steel, 30 mm in diameter, decorated with a 1 cm ball, that sits just under the head, in the groove behind the rim.

The principle: like a miniature cock ring, it slows the return of blood from the glans. The result: the head stays fuller, firmer, shinier, and reacts to the slightest contact.

Its strong points

Sensitivity multiplied. A taut head, stretched skin: the tongue, the hand, the rub of a condom or a tight ass take on a whole other dimension.

The ball, a pressure point. You can aim it at the frenulum, on the underside, to add localised pressure with every movement, or towards the top for a more visual effect.

A jewellery look. Slim, polished and discreet, it hints at a piercing without being one. A head circled in steel is a detail that makes an impression in photos as well as in bed.

Steel, simple and healthy. Smooth and non-porous, it cleans in seconds, doesn't wear out and works with all lubes.

How to enjoy it

When jerking off, the swollen head reacts to every pass of the hand: arousal builds faster, the sensation is sharper. During a blowjob, your partner plays with the ball with the tip of his tongue and feels your head harder between his lips. For the top, it brings extra sensation with every thrust.

If you're a beginner, wear it a few minutes, soft and then erect, to discover the effect. If you're experienced, combine it with a cock ring at the base for a double restraint, keeping the durations short.

How to put it on

• When soft, apply a little lube to the head and inside the ring.
• Slide the head through the ring compressing it gently, until the ring settles behind the rim.
• Orient the ball according to the effect you want.
• To remove it, wait until the erection has gone down, lubricate and slide it off over the head.

Safety

The glans is a highly vascularised area: limit wear to 15 or 20 minutes and never fall asleep with it on. Take the ring off as soon as you feel pain or numbness, or if the head turns cold or purplish. If it takes force to put on, it's too small for you: don't push it. A rigid ring can't be cut: if it gets stuck, apply cold and lube and, if that isn't enough, go to the emergency room without delay.

Care

Wash it in hot soapy water after every use, rinse it, dry it and store it separately to preserve its polish.

Technical specifications

FAQ — Your questions, our answers

Q: Where exactly does a glans ring go?

A: Just behind the rim of the head, in the groove that separates it from the shaft. It goes on when you're soft, with a lubricated head.

Q: Is 30 mm the right size for me?

A: The ring should pass over the head when soft without forcing and hold it firmly once erect. If it sticks going on or is already tight when soft, it's too small.

Q: How long can you wear it?

A: Around fifteen minutes is a good guide. Take it off as soon as the erection goes down or at the slightest discomfort.

Q: Can you wear it with a cock ring?

A: Yes, many people like to combine the two. The restraint is then stronger: shorten the time and watch the colour of the head.